tri-cell toutorial

Stalker · Post by **Stalker** » Mon May 05, 2003 3:01 pm

i never seen one any where why not put it up on the Pimpin site

hogjowlz · Post by **hogjowlz** » Mon May 05, 2003 3:52 pm

its the same as a dual but you daisy chain a third one. for bits i find it a waste. you just peel out.

sessiz · Post by **sessiz** » Mon May 05, 2003 7:00 pm

I agree with hog on this one. Unless you're using an older zip or a heavy diecast body 3 cells are really just a waste for anything other than straight drags.

Stalker · Post by **Stalker** » Tue May 13, 2003 11:14 am

what u got against Drags pimp'n ?like i said i never seen a tuort. on that so why not do it tha pimpin way

( STRAIGHT GUNIN ) *EDIT* yo wedgie king (hogs) R u tha same dude who talks on tinyrc.com? if so i must say your jb weld idea is BAD A$$. So r tha vids. u produce ! Props 2 U

hogjowlz · Post by **hogjowlz** » Tue May 13, 2003 11:44 am

THANK YOU

trust me im all about more speed and power but i havnt had good luck with 3 cells. it throws the weight off and your tires just peel out. you will also need more juice to charge it up. ive got my dual cells running well enough. but to ad another cell in the circuit you just run from the positive of the second cell(the one that sits above the heatsink) to the negative of the third one and then run a wire from the positive of the third one to the negative of the original battery(the one that sits inside the chassis. where you are gona fit all 3 is up to you. it can be done but its gona be tight.

you would be better off getting a lithiumpolymer cell 3.7v that weighs as much as one nimh cell.