Anybody ever tried to make lambo doors on a bit?

sidewinder · Post by **sidewinder** » Tue Jun 19, 2007 10:05 pm

I've been searching around the forum but I havn't seen any lambo doors, any one tried this? And yeah I realize the interior would leave a little to be desired.

Post by **CaboWabo** » Wed Jun 20, 2007 10:02 am

Sinned did:
http://bitpimps.lixlink.com/pages/phpFo ... php?t=5568

crazydave · Post by **crazydave** » Wed Jun 20, 2007 10:11 am

CaboWabo wrote:Sinned did:
http://bitpimps.lixlink.com/pages/phpFo ... php?t=5568

Aren't those more like gullwing doors? I don't think I've ever seen lambo doors on a bit. Lambo doors open out, then twist up. That's tricky because it pivots on 2 axis.

Post by **CaboWabo** » Wed Jun 20, 2007 12:00 pm

crazydave wrote:Aren't those more like gullwing doors? I don't think I've ever seen lambo doors on a bit. Lambo doors open out, then twist up. That's tricky because it pivots on 2 axis.

Yea, those are gullwing doors. The Lambo's doors are a hybrid of the gullwing.

Lamborghini uses a design which is a hybrid of the conventional and gull-wing design which is generally referred to as a "scissor", "jack-knife" in which the door is still hinged at the front but swings upward from the car while staying parallel with the edge.

frizzen · Post by **frizzen** » Wed Jun 20, 2007 2:06 pm

Like Cabo said, "Lambo" doors are Scissor doors, they just go straight up.

Doors that twist out at the bottom and go up are "Batwing doors"

sidewinder · Post by **sidewinder** » Wed Jun 20, 2007 6:03 pm

The Gullwings are cool too, so I guess I'll have to break new ground. Ok more likley-break a prefectly good bit. let you know if it works.

..tiny little airbags to raise and lower it would be my ultimate fantasy mod but if I try that and the doors there may be no room left for the internals. but....

SuperFly · Post by **SuperFly** » Wed Jun 20, 2007 6:14 pm

I would think the best way to pull it off on a bit would be some kind of dampened hinge, or to have it spring-loaded and held closed with a latch.

SHAUN · Post by **SHAUN** » Wed Jun 20, 2007 6:38 pm

A magnet would be a good latch.

sidewinder · Post by **sidewinder** » Wed Jun 20, 2007 7:09 pm

Or maybe a van or suv, and with the extra room an old zap se steering servo and second board (diff frequency of course) to push pull the doors open and closed. Digital Proportinal doors!

DarkTari · Post by **DarkTari** » Sun Jun 24, 2007 4:57 pm

SuperFly wrote:I would think the best way to pull it off on a bit would be some kind of dampened hinge, or to have it spring-loaded and held closed with a latch.

Hinge dat bitch on the A pillar and be done...

r/cdrifter7 · Post by **r/cdrifter7** » Wed Jun 27, 2007 12:55 pm

simpleest and most effective way^^^^^^^

jordanQ · Post by **jordanQ** » Tue Jul 03, 2007 12:33 am

crazydave wrote:
CaboWabo wrote:Sinned did:
http://bitpimps.lixlink.com/pages/phpFo ... php?t=5568
Aren't those more like gullwing doors? I don't think I've ever seen lambo doors on a bit. Lambo doors open out, then twist up. That's tricky because it pivots on 2 axis.

fake lambo doors are tricky. REAL lamborghini doors open directly up, they don't pop out or anything.

so in a way your right, the "lambo" doors your describing would be tricky.