motor/pcb question

General discussions, new info, and all stuff that's how you say, off the hook. Bit, ZZ, SE, MT, SS... as long as it's micro, it's here.
Post Reply
User avatar
kvik369
bitPlaya'
Posts: 179
Joined: Wed Dec 03, 2003 6:59 am
Location: pa

motor/pcb question

Post by kvik369 »

I did a dual on a clone and it seems to run better (faster, more torque) with my lower speed clone motors than with my 4.2 or Phast motors. Is it possible that the pcb will not work sufficiently with the faster motors?
Top
Post Reply

Return to “Bit / Zip Discussion”