bitPimps.lixlink.com

hello my car is having some problems at the moment...its not turning and so i checked the steering wires and they were all connected perfectly fine no damage done on them. then i checked my other wires and there all connected too. so what might be my problem?

any input welcome
thanks
-micro

is it a zip or bit? well ne ways somthing happend to mine and the pcb was scraping on the tire so i pushed it back and unscrewd the screw and put a tire in there and its doing fine better than my new one.
(my zipzap se)

Sky

its a original bcg mosfetted and i tryed turning it with no wheels and just the magnet and magnet holder and it still didnt work

thanks for trying
-micro

sounds like metal under the chassis. or the rear axle is loose. take the wheels off and reglue

my axle is already jbwelded and there is no metal under the chassis. also please keep in mind its not turning at all

thanks for tryin hog
-micro

check the inside of controler.. check if ne wires broke free, thats what happend to my original and had to put a jumper wire in cuz it wasent turning.

nope it wasent my controller

damn dood u got a real problem ther, sorry i wont b able to help u
but im sure some of the other pimps would like too

Sky

i know thanks for trying tho

anyone else? please help

-micro

steering magnet?
or - are your steering wires crossed and all mushed overlapping eachother?
if so, straighten them as much as possible, you might have a short.

i had the wires from the left coil soldered to the L and R pads and i had the right coil soldered to the postive pad and i just soldered them back

thanks guys

"look at the big brains on brad here"