bitPimps.lixlink.com

Took apart a zzse yesterday and came upon a white wire that had lost its place. ANyone know what this wire is for and if its + or -? THe steering and throttle seem to work fine without it, i find that odd.

THanks

STG

Do the lights still work?

yep, the lights all work. I tried to ground it and the car wont work, with it connected to + it works but with no change if its connected or not (as far as i can tell) all of the prop works correctly, im quite confused.

STG

Whelp I have no clue, sorry.
What about the charging, anything fishy there?

hmm, i suppose that the charging could have something to do with it,im not sure. IF thats the case than it doesnt matter, i dont use the stock charging system on this particular bit anyways. ANyone else have an idea?

STG

It might be the channel assign from the original controler.

Zenith wrote:It might be the channel assign from the original controler.

That's what I'm betting.

yeah, its about the only thing it could be. Well, thats one less wire i have to re connect. Everything else seems to work just fine. Thanks guys


STG

Zenith wrote:It might be the channel assign from the original controler.

Just off hand, that's what I remember it to be.

Zenith wrote:It might be the channel assign from the original controler.

just peeked inside mine, you all win a cupie doll

there was only one white wire inside, it goes from the pcb (lemme know if you wanna know where, only got 1 blurry pic) to the right side charging pad (the one behind the servo motor).

Thanks a ton guys, Its not really a big deal since im not using the stock charger (now that i now thats what it is and not something important)

A big help as always.

THanks

STG

if you're only ever gonna use ch1 then you can live without the wire. the default channel in the car is ch1, anything else needs to be programmed by the proper controller and through that wire.