I want these before I mod again.

cj · Post by cj » Thu Jun 12, 2003 2:49 am

http://www.modelcargarage.com/mcg_displ ... =2238&rp=0
MCG-2238 PHOTO-ETCHED SAW BLADES
Etched in 0.85 Stainless Steel

noxorc · Post by **noxorc** » Thu Jun 12, 2003 5:40 am

Here's a $1 towards yer goal drive!
How much ya got now? $2?

Post by **CaboWabo** » Thu Jun 12, 2003 8:24 am

wow, I bet those make some great cuts...

noxorc · Post by **noxorc** » Thu Jun 12, 2003 8:27 am

Just call him Lefty for now on.

crazydave · Post by **crazydave** » Thu Jun 12, 2003 10:29 am

Those should work well. I scrape the tip of my knife back and forth to cut to cut through thick plastic. That's basically the same as sawing.

Post by **CaboWabo** » Thu Jun 12, 2003 10:33 am

same here, you know me, livin on the edge...
I always use an x-acto knife and slice me a nice guide line to follow, then I start going over it again adding pressure until I'm cutting through.

PiMp_C · Post by **PiMp_C** » Thu Jun 12, 2003 10:36 pm

CJ, where in TN do you work? Im in TN, I PMed you, you look familier.