Page 1 of 1
27MHz and 27Mhz channel A do interference???
Posted: Tue Aug 15, 2006 7:05 am
by M_@rt_In
can i race at the same time microsizers one with freq 27MHz and second 27Mhz A (or other channel b,c)??? do they interference???
Re: 27MHz and 27Mhz channel A do interference???
Posted: Tue Aug 15, 2006 10:09 am
by sg219
M_@rt_In wrote:can i race at the same time microsizers one with freq 27MHz and second 27Mhz A (or other channel b,c)??? do they interference???
Try it.
You might get a small glitch or two.
ZZSE's are 6 channels. They tend to glitch a bit for me.
Posted: Wed Aug 16, 2006 12:43 am
by stampede_dude
I seem to remember my zipzap would half respond when it was on channel 1 and my controller was on channel 6.
Posted: Wed Aug 16, 2006 1:41 pm
by frizzen
Microsizers are not ZZ-SE. Microsizers use tuning coils on the car, these are NOT selective at all. Racing with them on same freq is probably going to work really badly.
With that said, try it. You might get lucky and have both cars tuned far enough off center that they'll block eachother's signal.
Posted: Wed Aug 16, 2006 3:59 pm
by SuperFly
I think he's talking about old-school straight "27mhz", vs. Super Bit or Microsizer Ferrari or Lambo "27A", "27B", "27C". I do know that you could usually run a 27mhz Microsizer Pro along side a 27mhz original without problems.
As said before, I would just try it. 27mhz can contain a huge range of individual frequencies. Just look at the fact that you can buy 12 xmod crystal sets that are all micro-variants of 27mhz.