ZZ PCB swap
-
mad_haxor
- Posts: 16
- Joined: Sun Dec 07, 2003 9:38 pm
- Location: da' hood
ZZ PCB swap
I am about to build a dual cell dragster out of a regular Zipzap. 
I was wondering which pc board would be the best to swap in.
I want something small so I can fit both cells in the bottom.
I would like one that is easily FET modded, and gives good performance.
Also something in a less common freq. like 35MHz.
Any help would be greatly appreciated.
Any ideas?
I was thinking of a regular bit or a lxx. what do you think?
I was wondering which pc board would be the best to swap in.
I want something small so I can fit both cells in the bottom.
I would like one that is easily FET modded, and gives good performance.
Also something in a less common freq. like 35MHz.
Any help would be greatly appreciated.
Any ideas?
I was thinking of a regular bit or a lxx. what do you think?
"been pimpin since.... been pimpin since....been pimpin" (Babypowder)
-
CaboWabo
- Site Admin
- Posts: 10259
- Joined: Tue Dec 10, 2002 4:05 pm
- Location: The Adult Table
- Contact:
yea I'd probably go with an the bit for the off freq.
but ya know... if ya really wanted, you could get a booster 57 mhz chassis, swap the pcb, dual cell it, and it can still be fetted if you really wanted
but ya know... if ya really wanted, you could get a booster 57 mhz chassis, swap the pcb, dual cell it, and it can still be fetted if you really wanted
Dear Life Cereal, Where do you get off? Part of a balanced breakfast and delicious? Who do you think you are? By now you may have guessed I'm speaking ironically and have nothing but good things to say about what you do. Life cereal do not change a thing.
