Microz motors

Murdoch · Post by **Murdoch** » Mon Nov 06, 2006 2:02 am

Okay, you guys know the little pager motors that go into these new(ish) cars at RS.. I'm tryin to find out what the specs are for them. mainly resistance and diameter.

frizzen · Post by **frizzen** » Mon Nov 06, 2006 9:16 am

I'd reccomend an ohm-meter and a vernier caliper.

Or was this a poorly phrased way to ask one of us to do that for you?

DarkTari · Post by **DarkTari** » Mon Nov 06, 2006 12:42 pm

frizzen wrote:I'd reccomend an ohm-meter and a vernier caliper.

Or was this a poorly phrased way to ask one of us to do that for you ?

Murdoch · Post by **Murdoch** » Mon Nov 06, 2006 1:22 pm

I just figured you guys may have the figures on hand.

because i'm thinking of doing a mod and I need as much info as possible.

Of course; i could have been an ass about it and said "and you figure yourself a bitpimp."

honda_s2000 · Post by **honda_s2000** » Mon Nov 06, 2006 3:03 pm

Murdoch wrote: Of course; i could have been an ass about it and said "and you figure yourself a bitpimp."

You could have, by all means.

But your about 100% less likely to get an answer.

Murdoch · Post by **Murdoch** » Mon Nov 06, 2006 3:38 pm

and that's why I didn't do it.

Anyways, i'll be heading down to the shack and see if they have them in stock. If it's what I think it is, I may have found the cure to the MM problems. Well, part of them anyways.