Monster ZipZap Monster

Use this gallery to show off your own garage of sleds - everything 1:32 and smaller - no matter if they be bangin, slangin, or just barely hangin.
Post Reply
backdrift
bitGangsta'
Posts: 402
Joined: Fri Dec 17, 2004 7:42 am

Post by backdrift »

Would a hs-55 micro ( the blue one ) actully fit in the front of a monster?
Top
User avatar
betty.k
bitPimp
Posts: 4090
Joined: Fri Dec 26, 2003 4:52 pm
Location: la la land
Contact:
Contact betty.k

Post by betty.k »

dude, read the thread. :???:
i used to be cool
Image
Top
backdrift
bitGangsta'
Posts: 402
Joined: Fri Dec 17, 2004 7:42 am

Post by backdrift »

ahh i missed that :-)

well anyways.. what mah are u going to use to charge that li-poly? and do u have any experiance with li-poly on xmods?
Top
User avatar
LBRC
bitGangsta'
Posts: 361
Joined: Sun May 02, 2004 1:25 am
Location: North West
Contact:
Contact LBRC

Post by LBRC »

The HS-55 was the closest I could come to the one used in Microsash’s ZZMT, you do have to cut it down and trim the chassis. I switched to a Kokam 145 mAh cell and assume the above question is how many amps do I use to charge the small cells. The answer depends on the manufactures recommendations. Unless I’m in a hurry I usually stick to 1C (the manufactures recommendation for all Kokam cells) using the Triton charger and a thermal sensor I have charged them up to 3C without damage, the cell will support discharges up to 5C.

Yes I have some experience with Xmods and LiPo’s:
http://bitpimps.lixlink.com/pages/phpFo ... php?t=4976

Edit: I keep loosing this link here are pictures of Microsash’s servo instillation, next time I take mine apart I’ll take a photo of what I did. I wish I had seen this before I started.

http://bitpimps.lixlink.com/pages/phpFo ... c&start=45
Top
Post Reply

Return to “Flossin' In Da' City”