cannonball jeep

HACHI-RYOKU · Post by **HACHI-RYOKU** » Sun Oct 02, 2005 4:53 am

Ah! I almost forgot about that. I still need to update that. I've been too busy.

civicsr2cool · Post by **civicsr2cool** » Sun Oct 02, 2005 9:32 pm

HACHI-RYOKU wrote:
Also, if you're gonna put this in a zip instead of a bit, then it will fit prfectly. It only needs a tiny bit extra room to lay flat, which the zips have. You'll have to cut off the extra attachments the board come with though. I still have plans for a zip and this set up. I just have too many other plans too.

ahh been there done that:

i am thinkin of lipoin it right now, just need some damn time

that spare lipo just screams zzmt though

HACHI-RYOKU · Post by **HACHI-RYOKU** » Tue Oct 04, 2005 5:16 pm

That MT motor could probably utilize the lipoly better. I burn out regular bit motors fast on my lipoly cars. That's why I got keen on SS motors. That lipoly wont burn them out.

At least it hasn't yet. They seem pretty sturdy.

civicsr2cool · Post by **civicsr2cool** » Tue Oct 04, 2005 8:52 pm

HACHI-RYOKU wrote:That MT motor could probably utilize the lipoly better. I burn out regular bit motors fast on my lipoly cars. That's why I got keen on SS motors. That lipoly wont burn them out. At least it hasn't yet. They seem pretty sturdy.

yeah the ss's are the only way to go with too many amps

civicsr2cool · Post by **civicsr2cool** » Sun Oct 16, 2005 4:50 pm

went with the pwnerer of the cannonball jeep for the lipo,

went big with the wire and i think it helped, my last mt with lipo sucked.