Slammed Silverado

evoraptor · Post by **evoraptor** » Fri Jun 24, 2005 2:01 am

is that an se? cuz i did the exact same thing with an se and had to chop part of the back off, and mine still runs. its not as low as yours but its off by about a mm in the front and back. I even have the same rims, and i swear i did not see this thread before.

civicsr2cool · Post by **civicsr2cool** » Fri Jun 24, 2005 9:10 am

its gettin sci-fi in here

good job on the lowest se in the world too

crazydave · Post by **crazydave** » Fri Jul 08, 2005 7:31 pm

evoraptor wrote:is that an se? cuz i did the exact same thing with an se and had to chop part of the back off, and mine still runs. its not as low as yours but its off by about a mm in the front and back. I even have the same rims, and i swear i did not see this thread before.

Nah, it's an OG ZZ.

I actually lowered my bed cover since I posted this. Took off the stock one, then cut a piece of plastic to fill the area under it. Level sanded, then painted it black. After I did that, I had to trim out a tiny little piece behind the cab to let one of the stacked FETs poke through.