bitPimps.lixlink.com

When i got home I went on a modding frenzy. I already had taken all the decals off. Its running a single 1.2v se cell in place of the stock cell, with zipzap rims all around and green gears. It will wheelie like mad forward to reverse. I also put a stock zipzap motor in it.

Nice car, very clean, I like the rims on that, pretty nice for ZZ hubcab style rims,
Ok this is a general question for anybody (not trying to detour your thread, sorry) but when putting a ZZ SE battery in a clone chassis does the battery go the opposite way than a reg cell?
Good job!

its ok man, not detouring the thread at all.

The polarity of an se cell is like that of a normal battery, you dont have to reverse the polarity on a single cell or the two cells in the pack if you use both. the flat end is negative, and the end with a bump on it is positive. I just bent the tabs in and put the se cell in there, and put some tape around it so the wires dont short. If youre using the 2.4 volt pack instead, the same theory applies, and you wont have to worry about it because the tab holds the two ends together than need to be and the what i said is correct for it also. I hope you understand what I mean...

Alright got Ya, Thanks, did You use rattle cans for paint or what? (not stock paint is it)

Yeah man its stock paint