micro esc w/reverse and bec

[Clint]

Size: 1.2" X 0.52" X 0.29" (Including Protective Covering)

http://www.banebots.com/pc/ELECTRONICS/BB-0309
28$

I'm just starting to jump into the micro-t scene, so not sure if this esc is already known, but it looks to be a perfect match for a stock micro-t motor. (or for a ZZMT)

Specifications
9 Amp Peak, 3.5 Amp Continuous (> 10 minutes at 24Vdc)

Full Current Limit and Thermal Protection

Proportional Forward and Reverse (no delay), 0-100% PWM

6 to 24 Vdc

Receiver Cable with Universal Plug Installed

Power/Motor Leads Installed (22 AWG High Strand Count Silicone Wire)

Size: 1.2" X 0.52" X 0.29" (Including Protective Covering)

Weight: .33 oz / 9.4 grams (With 12" Cable and 6" Power/Motor Wires)
0.12 oz / 3.3 grams (Without Cable/Wires - Reference Only)
+5 VDC BEC with Over Current, Short Circuit and Thermal Protection

Neutral signal (center stick) safety start-up when powered on

Safety shut-down when RC signal is lost with auto recovery

Motor brake on neutral signal and direction change. Helps protect gears from over stress.
All FETs are industrial/automotive grade components. Not commercial grade