bitPimps.lixlink.com

Once again I came across something different at Walmart. A 1/32 Mack truck r/c. About the size of a Mini-Z/Xmod. You guys were talking about trucks so here you go.

http://www.planettoys.com/home/products ... aspx?d=266

Normally I try these cheap r/c's and end up bringing them back. But this one I think I'll keep. Not too much to tell. Haven't opened it up yet. Seems to be a standard bit type r/c, uses 3 AAA and 1 9-volt. Turn radius is wide, internal antennea, and speed is decent for a under $15 truck. Has potential. There's also a Chrysler 300 (not on web site).

Mini-t electronics

or even an iwaver board

honda_s2000 wrote:Mini-t electronics

or even an iwaver board

Hmmm, an Iwaver board and wire the running lights in with the headlights?

Not sure what you ment there dave.

Allthough , I wouldnt want to wire up with the headlights anyway , It pisses me off the way they wire to the motor , so unless you set a pretty large positive throttle trim , they stay off untill you accel. That looks goofy when you let off the throttle.

Wire the running lights with a 9v or something...

Forgot to mention - there'a also four channels per frequency