Page 1 of 1
1:32 scale xmod H2 UPDATED
Posted: Fri May 27, 2005 12:38 pm
by Tuner1989
before i start off this is one of my first projects like this and i was on a 20 dollar budget so no fancy servos or lipos yet
I got this crappy hummer at wal-mart and it was slow as hell and was not porportional but it had a perfect space for a 130 size motor and xmod electronics which i had laying around.
i still have to clean up alot of the excess glue and make everything look nice and clean but here is some wip pics.
just begging for 2 AA liths
more pics and updates soon hope you like
Posted: Sat May 28, 2005 2:28 am
by betty.k
you'll have to cut a huge hole in the body if you want the servo to sit there. but it should be fun, good luck!
Posted: Sat May 28, 2005 7:28 am
by backdrift
Messy, but good luck..
Posted: Sat May 28, 2005 11:52 am
by Tuner1989
UPDATE:Yeah i got out the dremel yesterday to make room for the servo and about the mess i have cleaned alot of it up and now its looking pretty clean the reason i had to use the glue in the first place is to keep the contacts in place etc. thanks for the comments ill have pics up later
Posted: Sun May 29, 2005 4:21 pm
by Tuner1989
Posted: Sun May 29, 2005 4:24 pm
by sg219
It don't look too bad.
What the hell is that on the hood? It ruins the whole rides look!!
Posted: Sun May 29, 2005 5:22 pm
by backdrift
Xmod battery clip, holding down 2 AAA's?
Posted: Sun May 29, 2005 6:29 pm
by Tuner1989
Well about the hood i had to dremel out the middle of the hood to have room for the servo right now i have some base plastic down for a little roof scoop im going to do with some putty then its going to recieve paint.
So no backdrift its not holding down 2 AAA this will take 2 AA liths and probably soon some li-poly. I still have alot of body work to do so right now its still a big wip. ill have some chassis shots with the body off up later.
thanks for the comments all
Posted: Sun May 29, 2005 8:38 pm
by backdrift
I tried..
Posted: Mon May 30, 2005 10:08 pm
by stampede_dude
you shouldve turned the servo on its side and put the electronics on top, it wouldve fit...
Posted: Tue May 31, 2005 12:46 pm
by Tuner1989
That was the first thing i tried when i got it i would of had a big ass hole in the wind shield if i even did get it to fit righ there. The crystal is almost hitting the roof to give you a idea of the inside room. im content with where the servo is.
