bitPimps.lixlink.com

I used the end of a ink pen tube, cut it to size filed down the rear knuckle until the hole sat even where its supposed to be and used a little bit of epoxy and hot glue to mount it.

Then use a regular, screw from the gen 1 xmod or something similar to mount it like regular. Dont over tighten though, make sure it travels with the suspension nice and flush and that the green arm sits at the proper height and not too low.

hey, Tuner1989. can you post those pics again ? my new evos rear knuckle
shatered into 4 pieces RS sucked on plastic quality choice.
Thank you

Would if i still had an evo, sorry dude.

Pretty self explanitory, use the ink cartarage make it fit and work!

it alright. it is self explanitory. i just wanted to see how it might look. guess i'll see it soon enough.
thanks anyway