Micro-T PCB and Evo Servo

fameless · Post by **fameless** » Thu Mar 01, 2007 8:28 pm

My Mini-T PCB arrived before my next Iwaver board, so I decided to do some hackery. Through trial and error, I got it to work, but barely. There's a lot of servo jitter, and it won't turn to the left fully. I'm running it off of RS IC-3 batteries. Here's the diagram:

I really don't know where to go from here. I'm sure I need a resistor or to in order to make these two components work together, but I don't fully understand how to check with a multimeter.

Thoughts or ideas? I really want to learn this stuff, but I don't know where to begin.

*Edit*
I think the problem is with the TX. It's from a Firelap 2.0 RTR. Gotta play around with the settings.

fameless · Post by **fameless** » Fri Mar 02, 2007 12:32 am

The connections are good, so if anyone else would like to try this project, there you go. As far as the servo jitter, I believe it's due to the TX. Guess I'll save up to get a better one. Pics:

I'm waiting on a long stencil chassis. Hopefully I won't need a chassis spacer (which I don't have) to mount my F1 body. I also need to resolder some connections and clean up the wiring. If I ever do another Mini-T conversion (of course I will) I'll get a female servo plug and splice the Evo servo wires into that instead of my ghetto direct solder to the male plug.

SHAUN · Post by **SHAUN** » Fri Mar 02, 2007 12:53 am

Thats just cool, good work, wanna sell that micro t?

fameless · Post by **fameless** » Fri Mar 02, 2007 1:05 am

I would if I had one to sell. The board was bought by itself.

*Edit*
I got my mini and micro confused. This is a Micro-T board.