Mustang Steering Problem
-
- bitPlaya'
- Posts: 149
- Joined: Sun Nov 06, 2005 5:27 pm
- Location: burley idaho
Mustang Steering Problem
OK i had got some more 'chargables and had been running my Stang and all was good. I had some bangs to the wall here and there, no biggy.
Until i had one sorta "big bang" right smack in the middle of the wall.
(Yes i had the body on, ever since i broke a front steering knuckle, i never drive it without the body)
Nothing looked damaged so I just pulled out of the wall (i had turned left to backup) and let go of the steering wheel on the controller and turned right, but the wheels remain left, i check things out and luckily nothing was binding, i wiggled the controller wheel and it went back to normal.
Ever since then, It will do that SOMETIMES not all the times but sometimes it will get stuck in one direction, just wiggle, then its fine.
So i decided to take the front end apart, and check it out, i took off the tie rod, and then put in the batteries and turn the controller on then the car and steered i watch the little nub the tie rod hooks too. Still a little sticky.
So i don't know whats wrong and i don't know what to do, Can you guys help?
Thanks, I hope this was legable too.
Until i had one sorta "big bang" right smack in the middle of the wall.
(Yes i had the body on, ever since i broke a front steering knuckle, i never drive it without the body)
Nothing looked damaged so I just pulled out of the wall (i had turned left to backup) and let go of the steering wheel on the controller and turned right, but the wheels remain left, i check things out and luckily nothing was binding, i wiggled the controller wheel and it went back to normal.
Ever since then, It will do that SOMETIMES not all the times but sometimes it will get stuck in one direction, just wiggle, then its fine.
So i decided to take the front end apart, and check it out, i took off the tie rod, and then put in the batteries and turn the controller on then the car and steered i watch the little nub the tie rod hooks too. Still a little sticky.
So i don't know whats wrong and i don't know what to do, Can you guys help?
Thanks, I hope this was legable too.
frizzen is a friend of mine
- crazydave
- bitPimp
- Posts: 6874
- Joined: Thu Apr 17, 2003 9:05 am
- Location: Koolsville
-
- bitProphet
- Posts: 3165
- Joined: Wed Apr 25, 2007 6:31 pm
- Location: Walmart
If you can pull the servo apart you might be able to re-position the gear (if it uses a round gear) sometimes only part of the gear is used. Or if you get lucky there could just be some loose plastic jaming the gears.
The smallest minority on earth is the individual. Those who deny individual rights cannot claim to be defenders of minorities. - Ayn Rand