mr-02 diff knowledge

LBRC · Post by **LBRC** » Tue Mar 14, 2006 7:12 pm

The bottom row of parts are laid out in the order they go back on the axle.

Something I posted at Nanospeed awhile back, post #2 talks about adjusting the differential:
http://server08.ipslink.com/~nanospee/f ... #entry1559

MafiaS · Post by **MafiaS** » Tue Mar 14, 2006 7:36 pm

BEAUTY! Thank you very much, that should do the trick...

dogbreathracing · Post by **dogbreathracing** » Sat Apr 29, 2006 8:10 am

HACHI-RYOKU wrote:Here's a some picks outlining the generals. Your ball diff should look very similar.

The extra little washers are mostly used for spacing on the wheels. You can put them on either end to do small adjustments. You should at least put one on the gear side of the axle. Also, in my picks you may notice that I used screw tightener to hold the half-screw in place in the last pick. I recomend this as those things like to come loose and you'll get those symptoms that you were describing.

These pictures were taken in reverse order as I was taking it all apart to clean it.

Also, this may be redundant, but don't forget to tighten the adjustment. If it's too loose you'll get these same symptoms.

Hope this helps.

Nice Diff!!! Does it come stock with the Hairball or was that extra?....LOL

payaso · Post by **payaso** » Sat Apr 29, 2006 2:33 pm

Those hairs are infact titanium, and are not stock. They are the PN Ti super hairs.

Welcome DBR.

silla

dogbreathracing · Post by **dogbreathracing** » Sat Apr 29, 2006 2:53 pm

Where do I get some?!?!?!?
Looks like a "got to have" custom part