bitPimps.lixlink.com

Make your own 40MPH+ motor for under $25USD.




http://www.woahnelly.com/plasmatomic/index.htm



Enjoy!

ph2t.

Ferris Bueller, you're my hero.

SCHWEET, ph2t that rocks man! nice job on that tut

might do this on my x-mod but was just wondering if i would need better fets. i know that the page to buy the motor says *fet req. for mini-zs* but what about x mods?


also, would i need and/or a heatsink?




thx

you may not need FETs for the new Xmod EVO but definately for the OG Xmod.

400th post

its an old one. what about a heat sink? req. to not burn up the engine or not really?

heat sink is always a plus. But since it's an old one, you'll need fets. Goto www.woahnelly.com and take a look at the turbos there. That is a good option. Ph2t would be the best one to answer you as he has/had an Xmod EVO. He burned it up with a hot motor but I'm not sure which one. Do some searching, either here or over on ausmicro is where it's posted.

Maxx

k thx alot

pimptothemax wrote:might do this on my x-mod but was just wondering if i would need better fets. i know that the page to buy the motor says *fet req. for mini-zs* but what about x mods?
also, would i need and/or a heatsink?
thx

goto the last page of the tutorial, your answers are there...

ph2t.

I was thinking that only aplied to mini-zs and not the xmods. I had heard somewhere that a triple stack of 4562 on an X would cause a stutter under hard acceleration, but the Zs wouldn't suffer this problem.

just do a 2x2 stack on the xmod, you can't fit any higher anyways.

k thx guys ill do some research

by the way would a wo nelly turbo work on an x-mod and protect the modded engine from blowing?

*1st generaiton x-mod*

and i geuss ill get a heatsink just to be safe


thx people


pimptothemax

anyone home?

not to be impationt but could someone please awncer me?

pimptoyourass wrote:k thx guys ill do some research

so was that a lie?