iWaver Conversion problem
-
- bitDisciple
- Posts: 1798
- Joined: Thu Jul 31, 2003 7:15 pm
- Location: Barbados
iWaver Conversion problem
Well, I'm trying to get my Xmod converted, but I ran into a little snag. I've soldered up the fets that I have here to the board. I decided to keep it 1x1 for testing before I attempt a stack.
Well when I put in the batteries the servo goes all the way to the left and sounds like it wants to go further. I've swapped the steering wires to see if it would steer full to the other direction, it doesn't. It still goes full left. When I turn the wheel on the controller I can hear it having an effect but it's not visible, the horn doesn't move.
I've attached a video of what happens, listen to the servo horn.
Oh BTW the same thing happened when the x'tal was not unstalled.
http://bitpimps.lixlink.com/pages/phpGa ... roblem.wmv
Maxx
Well when I put in the batteries the servo goes all the way to the left and sounds like it wants to go further. I've swapped the steering wires to see if it would steer full to the other direction, it doesn't. It still goes full left. When I turn the wheel on the controller I can hear it having an effect but it's not visible, the horn doesn't move.
I've attached a video of what happens, listen to the servo horn.
Oh BTW the same thing happened when the x'tal was not unstalled.
http://bitpimps.lixlink.com/pages/phpGa ... roblem.wmv
Maxx
-
- bitDisciple
- Posts: 1798
- Joined: Thu Jul 31, 2003 7:15 pm
- Location: Barbados
-
- bitDisciple
- Posts: 1798
- Joined: Thu Jul 31, 2003 7:15 pm
- Location: Barbados
but I swapped the pot wires and got the same result. one of the wires has a 3.3k resister on it, I thaought that would have been the problem, but when I switched the wires (expecting the horn to swing the other direction) it didn't change anything.91LudeSiT wrote:looks like the POT wires are reversed or hooked up wrong
- betty.k
- bitPimp
- Posts: 4090
- Joined: Fri Dec 26, 2003 4:52 pm
- Location: la la land
- Contact: