Page 1 of 1
Dove into airbrushing
Posted: Mon Jun 02, 2008 8:05 pm
by Murdoch
Couple days ago, I hit the hobby shops to resupply my painting area. I spotted the guy who's into airbrushing and started to talk to him about what I wanted to do.
Long story short he recommended a badger 250. nice and simple but allows me to adjust the spray width.
so I've been working with it for the day using some faskolor paints and man oh man this stuff is addictive.
Posted: Mon Jun 02, 2008 8:38 pm
by payaso
Cut you some 2 litre bottles up for practice materials...
Keep us posted.
silla
Posted: Tue Jun 03, 2008 2:24 am
by Murdoch
payaso wrote:Cut you some 2 litre bottles up for practice materials...
hey thanks.. when can you send them over?
Had an idea for a paintjob for the RX8 i have sitting here. fades and pinstripe flames. My fades need some work and I need to figure out how to keep the trim tape from lifting.
Posted: Tue Jun 03, 2008 2:54 am
by frizzen
Burnish the tape edges more before you lay paint. If you're working on clear plastic it's easy to see the masking change color as you get the all the air out for a better seal.
Posted: Tue Jun 03, 2008 3:19 am
by Murdoch
frizzen wrote:Burnish the tape edges more before you lay paint. If you're working on clear plastic it's easy to see the masking change color as you get the all the air out for a better seal.
yea I did that. I think what happened is the first coat hadn't cured enough. Airbrushing and it's paints are completely new to me right now.
Oh well, it's good enough for a test. at least I know what the effect will do.
Posted: Tue Jun 03, 2008 8:53 am
by crazydave
Airbrushing is addicting and fun, at least it is for me.
Keep at it, it's frustrating sometimes.
If your using Pactra masking tape, or Parma masking film, you can warm it with a blow dryer to help conform to contours so it doesn't lift, but I'll tell ya, I've learned that you should be laying the paint light enough that it doesn't run under the tape when it lifts.
Here's a couple more tips I picked up recently, try using Createx Airbrush colors. Bonds to Lexan as well if not better, and its cheaper. You can pick them up at most craft stores for $2-$3 a bottle. Use transparent colors, you will have so much more control over them, and you have the bonus of being able back them with white for solid colors, or silver for a metallic look.
