where do i get alloy rims from?

DrayGo · Post by **DrayGo** » Mon Jul 19, 2004 2:07 am

I'm from Australia, and was just wondering where ya get the alloys from?
also if anyone knows of a good online shop for hop-ups and bodys.
thanks
DrayGo

betty.k · Post by **betty.k** » Mon Jul 19, 2004 2:13 am

g'day bloke!
http://www.scala43.com/scala43/rad.htm

LoRDDeVO2 · Post by **LoRDDeVO2** » Mon Jul 19, 2004 6:19 am

Which size fits the bits better? 8.3mm, 9mm 10mm?

DrayGo · Post by **DrayGo** » Mon Jul 19, 2004 8:15 am

thanks for that
I only just got my first micro, its a bit skyline
I've got some great ideas it and this site has been mega helpful
thanks again guys

DrayGo

sessiz · Post by **sessiz** » Mon Jul 19, 2004 9:02 am

LoRDDeVO2 wrote:Which size fits the bits better? 8.3mm, 9mm 10mm?

I'ld say stick to 9mm.

z-beam · Post by **z-beam** » Thu Jul 22, 2004 6:55 am

draygo, you seen ausmicro yet?

DrayGo · Post by **DrayGo** » Fri Jul 23, 2004 4:58 am

just briefly, dont get much time on the net now days
(full time student and tutor)
but i will go over and have a proper look
DrayGo