Page 2 of 2
Posted: Wed Nov 02, 2005 9:56 pm
by Cheesehead
Not a bad idea. I actually just made some out of copper tubing, but I'll dig out a spare floppy drive and see if it works.
New question: What's the best way to drill out the inside of a ZipZap gear to mount it on a larger axle?
Re: hhh
Posted: Wed Nov 02, 2005 11:04 pm
by Nasphere
SHAUN wrote:or get a small drill bit. somthin like that.
No shit...
ph2t wrote:People are mean to you because you're a fucking idiot.
Nuff said.
Posted: Thu Nov 03, 2005 12:06 am
by Nasphere
People on this forum are 'inteligent' (for the most part). Repetition is bad...
To correct what you said...
Original:
"Just use a little hand drill thats wat i did or get a small drill bit. somthin like that."
(Snip snip)
What you should have posted:
"Try a little hand drill."
If you don't want to get burned, keep the stupid posts to a minimum.
Posted: Thu Nov 03, 2005 5:42 am
by SHAUN
Thank you nas.
Posted: Thu Nov 03, 2005 6:20 am
by beanoman
Edit- Jolly chap edited his message..
Posted: Fri Nov 04, 2005 7:13 am
by Nasphere
Back to the topic at hand... Cheese Ball, here is an example of one i did a while ago...
Posted: Fri Nov 04, 2005 4:31 pm
by Cheesehead
Wow, that's impressive. Could you tell me how you did that?
Posted: Sun Nov 06, 2005 10:17 pm
by Cheesehead
Can anyone identify those bearings?