Re: Complete custom, build thread.
Posted: Thu Dec 17, 2009 12:39 am
Here is another good site for micro rx's.
http://www.microflight.com/Online-Catalog/Receivers
I got one of these for a TTTT I have in the works. It doesn't have reverse from the motor plug either, but someone on Scale4x4rc told me that if you have a spare speed control and pot from a servo, wire up your motor to the ESC and hook it up on one of the other 3 channel's available. It doesn't say anything about LVC, but it does suggest Li-Po as the power source so it might have some protection built in. It's a nice advanced little RX/ESC combo. Oh and it can be set for brushless or brushed motors.
Edit:
Just saw this under the basic features:
• Single Cell Low Voltage Cutoff
as well as:
• 4 PPM Channels
• On-Board Speed Controller
• Programmable Servo Reversing
• Programmable Brushless output
• 2 cell Capable (10v)
http://www.microflight.com/Online-Catalog/Receivers
I got one of these for a TTTT I have in the works. It doesn't have reverse from the motor plug either, but someone on Scale4x4rc told me that if you have a spare speed control and pot from a servo, wire up your motor to the ESC and hook it up on one of the other 3 channel's available. It doesn't say anything about LVC, but it does suggest Li-Po as the power source so it might have some protection built in. It's a nice advanced little RX/ESC combo. Oh and it can be set for brushless or brushed motors.
Edit:
Just saw this under the basic features:
• Single Cell Low Voltage Cutoff
as well as:
• 4 PPM Channels
• On-Board Speed Controller
• Programmable Servo Reversing
• Programmable Brushless output
• 2 cell Capable (10v)