Page 1 of 1
Stoli's Fairlady
Posted: Wed Sep 24, 2003 6:17 pm
by Stoli
Hey guys got my shiat from Toyeast on Monday and just finished my first pullback.
I just transfered the wheels from pullback to bit. No modding except cut hibs off inside of rim on 1 side.
Posted: Wed Sep 24, 2003 6:35 pm
by sessiz
Lookin good stolsi.
Posted: Wed Sep 24, 2003 6:45 pm
by dragula
very nice, unfortunately the Z body doesn't lower too far
Posted: Wed Sep 24, 2003 7:06 pm
by hogjowlz
it dont need lowering its a sweet shell.
Posted: Wed Sep 24, 2003 8:25 pm
by VooDooMafia
Nice I like the grey pullback rims
what did you use to fill in the holes on the back rims? or are they the same size as the normal axle unlike the gen 1 pullbacks?
I should have got that pullback
didn't do it for me from the pic damn lol
Posted: Wed Sep 24, 2003 9:14 pm
by Stoli
Thanx guys. I may paint her up one day?
As for what I did,
Fronts: Took rim off knuckle. Replaced DONE
Rears: Took both rims off replaced with new,cut one side down a bit. Cut a tiny bit of the axl back. DONE. No spacers required with the Fairlady.
Posted: Wed Sep 24, 2003 11:01 pm
by VooDooMafia
Stoli wrote:Thanx guys. I may paint her up one day?
As for what I did,
Fronts: Took rim off knuckle. Replaced DONE
Rears: Took both rims off replaced with new,cut one side down a bit. Cut a tiny bit of the axl back. DONE. No spacers required with the Fairlady.
Nice I was gonna toss the gry rims on one of my cars but didn't want to be bothered rght now to fill the holes in.
Again I like that shell
Posted: Thu Sep 25, 2003 9:44 pm
by Yugo DSC Maxxer
Sick car Stoli!!
I love that 350Z!
Posted: Tue Sep 30, 2003 10:58 pm
by bdebde
dragula wrote:very nice, unfortunately the Z body doesn't lower too far
I managed to get one lowered pretty well. I even need to shave the rear wheel well a bit. Here it is compared to stock:
And another compared to the pullback mod:
hogjowlz wrote:it dont need lowering its a sweet shell.
I always thought it needed lowering