Page 1 of 1
where do i get alloy rims from?
Posted: Mon Jul 19, 2004 2:07 am
by DrayGo
I'm from Australia, and was just wondering where ya get the alloys from?
also if anyone knows of a good online shop for hop-ups and bodys.
thanks
DrayGo
Posted: Mon Jul 19, 2004 2:13 am
by betty.k
Posted: Mon Jul 19, 2004 6:19 am
by LoRDDeVO2
Which size fits the bits better? 8.3mm, 9mm 10mm?
Posted: Mon Jul 19, 2004 8:15 am
by DrayGo
thanks for that
I only just got my first micro, its a bit skyline
I've got some great ideas it and this site has been mega helpful
thanks again guys
DrayGo
Posted: Mon Jul 19, 2004 9:02 am
by sessiz
LoRDDeVO2 wrote:Which size fits the bits better? 8.3mm, 9mm 10mm?
I'ld say stick to 9mm.
Posted: Thu Jul 22, 2004 6:55 am
by z-beam
draygo, you seen ausmicro yet?
Posted: Fri Jul 23, 2004 4:58 am
by DrayGo
just briefly, dont get much time on the net now days
(full time student and tutor)
but i will go over and have a proper look
DrayGo