Need Help with the DC Mod (betty-K or any of the gurus)

Getting bad reception? Got questions about motors, gears, and batteries? Learn how to make it go faster, roll smoother, and more in here.
Post Reply
mailman
bitHood
Posts: 33
Joined: Wed Nov 12, 2008 3:16 pm
4 + 3 =: 0
antispamboolean: No
Location: florida
Contact:

Need Help with the DC Mod (betty-K or any of the gurus)

Post by mailman » Wed Jan 08, 2014 8:32 pm

Ok, My question for this Mod is, the Atmel chip had 8 terminal 4 on each side. By the picture we can see the 4 wires solder to the board were the chip is placed. I can see the the corner wires are probably making contact with the corner terminals, But how about the 2 center wires? They just seemed solder to the board and not making any contact with the chip. Can anyone give a bit more info on this?


Image
1993 300zxtt

User avatar
betty.k
bitPimp
Posts: 4089
Joined: Fri Dec 26, 2003 4:52 pm
4 + 3 =: 0
antispamboolean: No
Location: la la land
Contact:

Re: Need Help with the DC Mod (betty-K or any of the gurus)

Post by betty.k » Fri Jan 31, 2014 7:10 am

to me it looks like pins 4 5 6 are the 3 wires counting from the bottom, the top wire appears to be pins 7 & 8.

don't quote me on that!
i used to be cool
Image

Post Reply