Power problems

Swavey · Post by **Swavey** » Wed Sep 10, 2003 11:51 am

I am a little confused...
My Bit will work when it is on the charger... but not when it is off... Its like its not getting charge

All the wires are connecting, and the charge plates seem to be fitting right. Any ideas?

hogjowlz · Post by **hogjowlz** » Wed Sep 10, 2003 11:54 am

its something with the battery circuit. recheck a wire may be boke inside the insulation.

micromatch · Post by **micromatch** » Wed Sep 10, 2003 12:02 pm

and also remember that the posotive side of the battery should be on the passenger side of the car (usa passenger side)

VooDooMafia · Post by **VooDooMafia** » Wed Sep 10, 2003 12:03 pm

I had the same problem awhile back. I had to re solder the wires and I also bent the plates in a bit works like new again

Swavey · Post by **Swavey** » Wed Sep 10, 2003 12:06 pm

Thanks for the help everyone. I think I found the problem, re-soldering now! Thanks again!

Swavey

cowfish_29 · Post by **cowfish_29** » Thu Sep 11, 2003 6:31 pm

whenever that happens, its usually a burnt out battery (too long charge, too much soldering iron heat...) yep, anyways...i'm out