ZZSE PCB in a ZZMT

chrome · Post by **chrome** » Mon Feb 07, 2005 7:48 am

I've accquired a ZZSE PCB that has been fetted with Code's DC mod. I'm wanting to put it into my MT. When I solder it in, all I have to do is connect the same steering leads that went to the ZZSE steering motor to the ZZMT steering motor, correct?

Later,
Chrome...

betty.k · Post by **betty.k** » Mon Feb 07, 2005 3:21 pm

that's half of it, you gotta do something about the servo pot too.

backdrift · Post by **backdrift** » Mon Feb 07, 2005 6:52 pm

did u do a 5k resistor??

chrome · Post by **chrome** » Mon Feb 07, 2005 11:19 pm

betty.k wrote:that's half of it, you gotta do something about the servo pot too.

Yeah, I'm going to have that pot in there. I'm actually looking at using the entire SE gearbox. It was pointed out to me that the MT steering motor would get easily pushed out of position. The gearbox looks like a smooth route...I'm weighing my options at the moment.

Later,
Chrome...