Cheap Motor holder

[Bit boy]

I finnaly found the solution to my motors rolling around my work area!

Materials:
One Microsnap motor package
Tape
Knife
scissors

1 cut out the bubble portion of the packaging
2 trace the edge of this on a part of the backing card
3 cut out and tape to the back of the bubble
4 mark holes ( i used a small nail )
5 cut holes slightly smaller than diameter of the motor
6 cut small slits from the holes
7 adjust slits and hole till motor fits
8 load your motors

I only made holes for four motors but from the looks of it you could make it fit up to 10 motors