Page 1 of 1
Help: Dual cell controller question
Posted: Mon Aug 11, 2003 3:46 am
by SkyLiNEz 4-eva!
okay, before i do a dual cell, i need help. i looked at CaboWabo's method of doin a dual cell, but he is using a Shen Qi Wei controller. how do you do this on a Microsizer 27 mHz controller? can u show me where to solder the 2 wires to w/ pics so it will b easier to figger out? thx for any/all help.
Posted: Mon Aug 11, 2003 8:13 am
by CaboWabo
you should be able to follow the same method.
just solder a wire from the positive(+) battery post to the (+) charging post, and then another wire from (-) to (-).
sorry, I don't have a pic of an MS controller though
Posted: Mon Aug 11, 2003 11:27 am
by SkyLiNEz 4-eva!
one utha Q: i got a S2000 body that i cut the top and rear out of, except the windshield so from the windshield back the whole thing is open all the way to the rear panel. how do i secure the battery? should i tape it to the heatsink or cut part of the battery casing and solder it, or how should i do it?
Posted: Mon Aug 11, 2003 1:03 pm
by CaboWabo
well mine just rests on the heat sink.
the wires running to and from the 2nd battery are short enough that it doesn't allow the 2nd battery to move.
Posted: Tue Aug 12, 2003 4:34 am
by SkyLiNEz 4-eva!
i like to watch HEE-HAW!!