bitPimps.lixlink.com

I finished my MS pro trying a dual cell, It's gutted out but i don't know how to wire and stuff. Also the solder isn't sticking to the batteries. So can i get a detailed tutorial for this mod.

i could try to do one later. doubt ill be able to get around to it tho.

but tips:

get a big blob of solder on the tip of the iron and kinda just drop it on there and let it cool for a few seconds. sanding the battery helps sometimes but isnt really needed.

I tried that but it still is not sticking to the battery.

http://bitpimps.lixlink.com/pages/artic ... 17&catId=1

You may have to use soldering paste or scratch the surface of the battery to get the solder to hold.

the way i've always soldered to a flat surface is to get a sharp knife and make little X's on the ends of the batt, it will hold so well you won't beleive

i found a tutourial for the internal dual cell, i have yet to try it tho.

internal dual cell

It isn't the easiest mod to do, but It also isn't the hardest. When everything is said and done, It all comes down to the wiring. When doing the internal mod, I built a wiring harness that kept everything neat and organized. After that was finished, it was just a matter of soldering it all together.


Project F-14GT-R

easy way to do a dual cell:

instead of soldering, get some electrical tape and some aluminum foil, and
do it the same way, jus w/o the soldering
NO SOLDERING NEEDED!, lol
jus the way i like it

no peace,

synj