motors

mekinhux · Post by **mekinhux** » Wed Jan 14, 2004 10:07 am

hello.

can someone please tell me with which motors can I use the white pinion rack without causing any damage? thanks

mekinhux

Post by **CaboWabo** » Wed Jan 14, 2004 6:46 pm

any should be fine... but have you tried the black pinion gear?

mekinhux · Post by **mekinhux** » Thu Jan 15, 2004 4:37 pm

hi.
thanks for your help. yes I have tried the black pinion gear, and I was wondering if the white would be better, because it comes with the tomy bit racer 3.0 motor. I have seen some japanese instructions where you are told not to use the white gear with 2.2 or 2.6 motors, only with 3.0, but I have received a 2.6 motor a few days ago and it comes with a white gear. I got questioned about this and decided to ask for help to some experts in the business

Thanks for your help once again

mekinhux

payaso · Post by **payaso** » Thu Jan 15, 2004 5:55 pm

The 7 tooth white pinion is not used on Bit Char-G cars.... It's intended for the "Bit Racers" they're the same, but non r/c.

the white will not mesh correctly with standard gearing. Unless you do some tweeking to it.

If you use the red gearing from the bit reacer, you could pull it off. (make it work)

That's the reason the 3.0 "Lucifer Rotor" comes with the white, and black pinions. That motor will work in either car.

Hope that helps.

silla

mekinhux · Post by **mekinhux** » Wed Jan 21, 2004 3:31 pm

Thanks for your help guys. I have been here for only one week or two, but I am really digging this forum.

mekinhux