Page 1 of 1
Help this pimp mod a controller fit for dual cell.
Posted: Fri Feb 20, 2004 9:08 pm
by TMP
ive looked around and around for a decent site which has a good tutorial on modding your controller to charge dual cell and i cant find anything. can somebody help me?
Posted: Fri Feb 20, 2004 9:09 pm
by hogjowlz
goto walmart
buy a boat
Posted: Fri Feb 20, 2004 9:45 pm
by CaboWabo
are you fuckin serious? you looked all around?
and this didn't help explain the controller?
http://bitpimps.lixlink.com/pages/artic ... 17&catId=7
Posted: Sun Feb 22, 2004 9:21 pm
by TMP
oh man! sorry about that, didnt look right under my nose. But anyway, i tried this on two of my bit controllers, and the red light stops normally and doesnt put any more char-g into the car than normal, my car runs normaly, with the dual cell... so that means the car must be ok right? hmm....
Posted: Sun Feb 22, 2004 9:35 pm
by CaboWabo
probably, if you're red light still comes on and goes off after 45 seconds, you haven't gotten the controller modified correctly.
Posted: Sun Feb 22, 2004 10:10 pm
by TMP
CaboWabo wrote:probably, if you're red light still comes on and goes off after 45 seconds, you haven't gotten the controller modified correctly.
hmm this is strange. after reading i went down and tried this on another clone controller. soldering when well, nothing went wrong. i did pos to pos, neg to neg. closed it up and tested..... same thing, the light comes and goes! i dont know what im doing wrong.
Posted: Sun Feb 22, 2004 10:21 pm
by CaboWabo
odd, but possible.
without a meter to tell how much juice is actually coming from the terminal it's hard to say 100%.
but, how long are you charging your car?
it should be at least double what you would normally charge it for.
when the batteries are warm - they're full.