Page 1 of 1
ZZSE PCB in a ZZMT
Posted: Mon Feb 07, 2005 7:48 am
by chrome
I've accquired a ZZSE PCB that has been fetted with Code's DC mod. I'm wanting to put it into my MT. When I solder it in, all I have to do is connect the same steering leads that went to the ZZSE steering motor to the ZZMT steering motor, correct?
Later,
Chrome...
Posted: Mon Feb 07, 2005 3:21 pm
by betty.k
that's half of it, you gotta do something about the servo pot too.
Posted: Mon Feb 07, 2005 6:52 pm
by backdrift
did u do a 5k resistor??
Posted: Mon Feb 07, 2005 11:19 pm
by chrome
betty.k wrote:that's half of it, you gotta do something about the servo pot too.
Yeah, I'm going to have that pot in there. I'm actually looking at using the entire SE gearbox. It was pointed out to me that the MT steering motor would get easily pushed out of position. The gearbox looks like a smooth route...I'm weighing my options at the moment.
Later,
Chrome...