Page 1 of 1
ZZ gen1 diagram
Posted: Fri Jul 21, 2006 2:07 pm
by nivlacs3z
Hey, The steering on my zz gen1 went out a LONG time ago while I was still into this stuff... heh so yeah, I'm trying to pick back up on where I left off. Anyways, the reason it went out is because one of the electromagnet wires crapped out on me. Could someone get me a pic or a diagram of what is suppose to go where? Thanks in Advance!!!
Posted: Fri Jul 21, 2006 4:28 pm
by Maxximum Attack
Some PCBs come labeled, I'm not sure about ZZs tho. Just look for solder dots and see if there is an L or an R next to it.
Posted: Fri Jul 21, 2006 4:39 pm
by crazydave
ZZ boards are labeled. One strand from each coil goes to "L" and "R". the remaining two strands go to V+. As to which strand goes where, you'll have to experiment as it seems to vary from car to car, but if you see 2 that are black, those usually go to the v+, but not always, from my experience.
Posted: Fri Jul 21, 2006 5:05 pm
by nivlacs3z
thanks! lol yeah the two L n R ones go right except the remaining black ones... idk what happened. I placed them in V+ but now it only turns one way. XD right is left and left is left. wth?
Posted: Sat Jul 22, 2006 9:20 am
by crazydave
nivlacs3z wrote:thanks! lol yeah the two L n R ones go right except the remaining black ones... idk what happened. I placed them in V+ but now it only turns one way. XD right is left and left is left. wth?
Is it trying to push in the other direction? (sounds like it to me) Figure out which coil is pushing instead of pulling and switch the wires on that coil.