bitPimps.lixlink.com

Changing the channels on the ZZSE is usually setting the channel you want on the TX, then putting the car on the charge bay and wait for the blinking light to go solid.

Does this procedure stay the same though if you've changed the battery configuration (like multi-cells or switching to Lipo)? If so, do you just pop the car IMMEDIATELY off the bay once the light is solid (so as to not ruin the custom battery)?

Thanks.

i reckon if you disconnect the V+ wire from the charger you should be safe.

to test the theory put some tape on the V+ tab before you charge, see what happens.