Page 1 of 1
Zip Zaps PCB Swap
Posted: Tue Sep 26, 2006 2:42 am
by footballarms
My Zip Zaps "Cars" just stopped working so I tried to do a PCB swap with an old microsizers pro. Everything is fine except I'm not sure where to connect the steering motor wires to. Has anyone done this?
Posted: Tue Sep 26, 2006 4:36 am
by Maxximum Attack
You can't use the MS pro board, this is because the 'cars' ZZs have a motor for steering and the MS Pro doesn't. That's the very basic gist of it. Someone else will chime in and give you a propper break down.
Welcome to the hood over-padded-fatguy's sport arms
I actually do like Football
Maxx