Aero ace/x-twin lipo?

stephane · Post by **stephane** » Thu Jan 18, 2007 9:44 pm

Hello,
Would it be possible to use the lipoly battery from the aero ace with a stock ZZMT? Or will it fry the board?If it would work, would i just have to attach it to the battery leads that are in my zzmt right now,or would I have to add anything to the board such as a resistor? Last but not least, could i charge it with the areo ace controller?

Thank you in advance,
-Stephane

betty.k · Post by **betty.k** » Thu Jan 18, 2007 11:33 pm

you can use a single lipo in a zzmt, it should be fine.

yes, just attach it to the existing battery leads.

use the aero ace charger only with that lipo. never ever incorrectly charge a lipo cell.

stephane · Post by **stephane** » Fri Jan 19, 2007 7:52 am

Also, when charge it, would i have to go through the aeroace pcb then to the lipo, or just straight to it?
thanks,
-Stephane

stephane · Post by **stephane** » Fri Jan 19, 2007 10:08 am

I just found out that the previous owner of this battery (my cousin) had accidentally touched the negative wire of the lipoly to the positive wire. Is it still safe to use?

-Stephane

betty.k · Post by **betty.k** » Sat Jan 20, 2007 12:20 am

stephane wrote:Also, when charge it, would i have to go through the aeroace pcb then to the lipo, or just straight to it?
thanks,
-Stephane

probably. i would to be sure

I just found out that the previous owner of this battery (my cousin) had accidentally touched the negative wire of the lipoly to the positive wire. Is it still safe to use?

probably not. does the cell look a little inflated? if so it's dead.

time for some schoolin'
http://www.batteryuniversity.com/