Cant f****** get this mini-z pcb epoch working

[Tuner1989]

I have it hooked up to what i believe is the correct way, but the servo just jitters back and forth, i can turn right and it'll go back to center for just a second then just go haywire again. Ugh, anyone have pics of the proper wiring arrangments. HELP

[betty.k]

sounds like the servo pot is fucked, mini z pots are the same size and value.

[Tuner1989]

New servo pot, same problem. Is my whole pcb fucked?

[SuperFly]

You really gotta have that servo pot strapped down solid. Even in a Mini-Z front end where it's wedged into the plastic housing, I've had to add shims and tightening screws to get rid of jitters.

[crazydave]

I don't know if this is any help, but I seem to remember centering the pot on the ZZSE helped to cure the jitters.

[Tuner1989]

So 2 years later, ive decided to try this mofo again. Anyone have any pictures of the proper wire hookup from Epoch steering elec's to the mini-z pcb?

[betty.k]

hope this pic is self explanitory.

you only need 2 wires from the pcb to the servo pot. you will also need to use the epoch pot as it's slightly a different shape. the miniz pot won't stay firm in an epoch chassis.

this could be the cause of your initial problem.