Better Tire Traction.
- BoneyskinX5
- bitHood
- Posts: 39
- Joined: Mon Apr 11, 2005 3:36 pm
Better Tire Traction.
This mod is so simple, it doesn't require pics. If you want pics, ill try to get them, but I can't promise you that.
Basicly a "sand your tire."
Tool:
Dremel with sand drum bit
ZZ Tires (or Bit tires?)
ZZSE/ZZ/Bit
1:Alright, grab a pair of your tires and put them on the axle of the 1/64th. I would recommend removing the motor and gears.
2:Now, start spinning your Dremel against your ZZ tire. I wouldn't go higher then 35,000RPM. Now that it is nice and smooth and grippy, go on the other side of the axle and repeat.
Note: Now don't be an idiot and try sanding the tires when they are on the knuckles.
3:Remove your front tires and put them on the rear axle, and repeat step2.
Don't complain to me if your 1/64th is flipping all over the place because of so much traction.
Enjoy.
Basicly a "sand your tire."
Tool:
Dremel with sand drum bit
ZZ Tires (or Bit tires?)
ZZSE/ZZ/Bit
1:Alright, grab a pair of your tires and put them on the axle of the 1/64th. I would recommend removing the motor and gears.
2:Now, start spinning your Dremel against your ZZ tire. I wouldn't go higher then 35,000RPM. Now that it is nice and smooth and grippy, go on the other side of the axle and repeat.
Note: Now don't be an idiot and try sanding the tires when they are on the knuckles.
3:Remove your front tires and put them on the rear axle, and repeat step2.
Don't complain to me if your 1/64th is flipping all over the place because of so much traction.
Enjoy.
- BoneyskinX5
- bitHood
- Posts: 39
- Joined: Mon Apr 11, 2005 3:36 pm