Quickie for the kid

crazydave · Post by **crazydave** » Thu Jun 26, 2008 11:05 am

I was organizing my shelves when I decided there just wasn't enough room for the 1/43rd SuperSlick MT, so I gave it to my kid, but he wanted a red one, so I whipped out a can of Duplicolor and said, "There", but he wanted black flames, so I broke out a flame template and layered some flames real fast, but then he wanted skulls too, so I told him maybe later this is good enough for now, I just wanted to organize my shelf.

A little rough, but not bad for about 45 minutes total time spent.

frizzen · Post by **frizzen** » Thu Jun 26, 2008 12:58 pm

Lucky (and pushy) kid!

Nice looking body, not sure if adding skulls too would make it look too busy.

Done any mods to it yet, or are you going to make him do them?

sidewinder · Post by **sidewinder** » Thu Jun 26, 2008 10:26 pm

LOOKS GREAT! If you do add a skull later maybe put it in the bed so it doesn't cover the great flamejob.

crazydave · Post by **crazydave** » Fri Jun 27, 2008 11:00 am

Oops, sorry, I said 1/43rd, I meant 1/25th, but you guys probably figured that out.

I tried to tell him it would clutter it up if I added skulls, and he pointed out there was room in the bed.

This ones pretty much stock. It's got the red motor in it, and other than the body that's it. I've got another one with broken steering that I'm going to stick an Iwaver board in... someday.

sidewinder · Post by **sidewinder** » Fri Jun 27, 2008 3:19 pm

crazydave wrote:Oops, sorry, I said 1/43rd, I meant 1/25th, but you guys probably figured that out.

I tried to tell him it would clutter it up if I added skulls, and he pointed out there was room in the bed.

The kid must be a genius! only us smart folks figgure this stuff out