| Last viewed - Nasphere's Gallery |
Steering mod 349 viewsAll closed up, ready to go!Aug 25, 2025 at 02:29 AM
|
|
Spin Blade crash test105 viewsFlying the Spin Blade from RadioShack.....Aug 25, 2025 at 02:29 AM
|
|
Diff project 377 viewsoutput shafts and spider gears.Aug 25, 2025 at 02:29 AM
|
|
Project Low Speed 151 viewsGone now, i disassembled the frame because it was a poor design.Aug 25, 2025 at 02:29 AM
|
|
Crawler expiriment 162 viewsTried a crawler gear and ONE bearing, SUCCESS!! works awesome with only one bearing. I placed it on the gear side to reduce axle play to allow for more accurate meshing of the gears. The other side is fine left stock.Aug 25, 2025 at 02:29 AM
|
|
Crawler expiriment 367 viewsThe underside. Taken to see the bearing and placement of the shaft.Aug 25, 2025 at 02:29 AM
|
|
Charger 261 views*fried the 555 circuit* oops... I have extra parts, so i can rebuild when I feel motivated.Aug 25, 2025 at 02:29 AM
|
|
SE mod 259 viewsAug 25, 2025 at 02:29 AM
|
|
zero center60 viewsbearing is directly over center of hub to eliminate bump-steerAug 25, 2025 at 02:29 AM
|
|
Steering mod 262 viewsFront view of cutout and gear.Aug 25, 2025 at 02:29 AM
|
|
Charger 164 views2 Charge rates, 2 output wires, a "new-cycle" button restarts charging/resets the charger.
Charger 1 = 120 seconds @ 300-600mA (selectable for dual cell)
Charger 2 = 120 seconds @ 1200mA (direct from 6V source for high-amps)Aug 25, 2025 at 02:28 AM
|
|
New Hubs58 viewsreplacing old hubs with new ones to reduce errorsAug 25, 2025 at 02:28 AM
|
|
| 52 files on 5 page(s) |
 |
|
4 |
|
