| Most viewed - Nasphere's Gallery |
Diff project 1277 views*Ended* sadly... I lack one piece to the puzzle: something to align the drive gear to the output gears.
|
|
SE mod 8274 views
|
|
Diff project 4272 viewsMoving source gear to side to accomidate a zip-motor.
|
|
SE mod 2272 views
|
|
Steering mod 3269 viewsAll closed up, ready to go!
|
|
Mid-engine 3269 viewsFully assemble, I could fit an extremely flat body on it. Maybe I'll lower the top edge and drop the body a little.
|
|
Project Low Speed 1267 viewsGone now, i disassembled the frame because it was a poor design.
|
|
SE mod 3265 views
|
|
Mini cars...263 viewsMini cars at an expo in the parking lot of the Queen Mary.
|
|
zero center262 viewsbearing is directly over center of hub to eliminate bump-steer
|
|
Crawler expiriment 1262 viewsTried a crawler gear and ONE bearing, SUCCESS!! works awesome with only one bearing. I placed it on the gear side to reduce axle play to allow for more accurate meshing of the gears. The other side is fine left stock.
|
|
Mid-engine 6262 viewsunder the PCB (sloppy solder on the motor can), mostly to show off the motor placement
|
|
| 52 files on 5 page(s) |
2 |  |
|
|
