Help: Dual cell controller question

SkyLiNEz 4-eva! · Post by **SkyLiNEz 4-eva!** » Mon Aug 11, 2003 3:46 am

okay, before i do a dual cell, i need help. i looked at CaboWabo's method of doin a dual cell, but he is using a Shen Qi Wei controller. how do you do this on a Microsizer 27 mHz controller? can u show me where to solder the 2 wires to w/ pics so it will b easier to figger out? thx for any/all help.

Post by **CaboWabo** » Mon Aug 11, 2003 8:13 am

you should be able to follow the same method.
just solder a wire from the positive(+) battery post to the (+) charging post, and then another wire from (-) to (-).
sorry, I don't have a pic of an MS controller though

SkyLiNEz 4-eva! · Post by **SkyLiNEz 4-eva!** » Mon Aug 11, 2003 11:27 am

one utha Q: i got a S2000 body that i cut the top and rear out of, except the windshield so from the windshield back the whole thing is open all the way to the rear panel. how do i secure the battery? should i tape it to the heatsink or cut part of the battery casing and solder it, or how should i do it?

Post by **CaboWabo** » Mon Aug 11, 2003 1:03 pm

well mine just rests on the heat sink.
the wires running to and from the 2nd battery are short enough that it doesn't allow the 2nd battery to move.

SkyLiNEz 4-eva! · Post by **SkyLiNEz 4-eva!** » Tue Aug 12, 2003 4:34 am

i like to watch HEE-HAW!!