Anyone know how to make bearings for a ZZSE axle?

Cheesehead · Post by **Cheesehead** » Wed Nov 02, 2005 9:56 pm

Not a bad idea. I actually just made some out of copper tubing, but I'll dig out a spare floppy drive and see if it works.
New question: What's the best way to drill out the inside of a ZipZap gear to mount it on a larger axle?

Nasphere · Post by **Nasphere** » Wed Nov 02, 2005 11:04 pm

SHAUN wrote:or get a small drill bit. somthin like that.

No shit...

ph2t wrote:People are mean to you because you're a fucking idiot.

Nuff said.

Nasphere · Post by **Nasphere** » Thu Nov 03, 2005 12:06 am

People on this forum are 'inteligent' (for the most part). Repetition is bad...

To correct what you said...

Original:
"Just use a little hand drill thats wat i did or get a small drill bit. somthin like that."

(Snip snip)

What you should have posted:
"Try a little hand drill."

If you don't want to get burned, keep the stupid posts to a minimum.

SHAUN · Post by **SHAUN** » Thu Nov 03, 2005 5:42 am

Thank you nas.

beanoman · Post by **beanoman** » Thu Nov 03, 2005 6:20 am

Edit- Jolly chap edited his message..

Nasphere · Post by **Nasphere** » Fri Nov 04, 2005 7:13 am

Back to the topic at hand... Cheese Ball, here is an example of one i did a while ago...

Cheesehead · Post by **Cheesehead** » Fri Nov 04, 2005 4:31 pm

Wow, that's impressive. Could you tell me how you did that?

Cheesehead · Post by **Cheesehead** » Sun Nov 06, 2005 10:17 pm

Can anyone identify those bearings?

bitPimps.lixlink.com

Anyone know how to make bearings for a ZZSE axle?

Re: hhh